User's Manual
Table Of Contents
- ARRIS Copyrights and Trademarks
- Patent Notice
- Safety Requirements
- Product Overview
- Installing the Wi-Fi Router
- Setting up an Internet Connection
- Setting Up a Wireless Network Connection
- Adding G.hn Extenders To Your Network
- Managing Your Wi-Fi Router and Connected Networks
- Start the Wi-Fi Router Web Manager
- Wi-Fi Router Web Manager Menu Options
- Get Help
- View the Wi-Fi Router Product Information
- Test Your Connection
- Set Up DHCP
- Set Up Dynamic DNS
- View Your IPv6 Configuration
- View Your USB Configuration and Status Information
- Disable LEDs on the Back Panel
- Back Up Your Wi-Fi Router Configuration
- Restore Your Configuration Settings
- Reset Your Configuration Settings
- Update Your Wi-Fi Router Firmware
- Exit the SBR-AC1200P Web Manager
- Protecting & Monitoring Your Wireless Network
- Prevent Unauthorized Access
- Change the Default User Name and Password
- Set Up Firewall Protection
- Set Up Remote Configuration Management
- Filter Devices Based on IP Address
- Filter Devices Based on IP
- Filter Devices Based on IP
- Restrict Wireless Access
- Prioritize Network Traffic Based on Media Type
- Configure Wireless Media Settings
- Set Up Parental Controls
- Set Up Port Triggers
- Set Up Port Forwarding
- Set Up the DMZ Host
Release 33 ISSUE 1.3 December 2015 SURFboard SBRAC1200P Wi-Fi Router User Guide
Copyright ARRIS Enterprises, Inc. 2015. All Rights Reserved. 6
Chapter 1
Safety Requirements
The ARRIS SBR-AC1200P Wi-Fi Router complies with the applicable requirements for
performance, construction, labeling, and information when used as outlined below:
Do not use product near water (i.e. wet basement, bathtub, sink or near a swimming pool,
etc.), to avoid risk of electrocution.
The product shall be cleaned using only a damp, lint-free, cloth. No solvents or cleaning
agents shall be used.
Do not use spray cleaners or aerosols on the Wi-Fi Router.
Avoid using and/or connecting the equipment during an electrical storm, to avoid risk of
electrocution.
Do not locate the equipment within 6 feet (1.9 m) of a flame or ignition source (i.e. heat
registers, space heaters, fireplaces, etc.).
Use the power cord included with the equipment.
Equipment should be installed near the power outlet and should be easily accessible.
In areas of high surge events or poor grounding situations and areas prone to lightning
strikes, additional surge protection may be required (i.e. PF11VNT3 from American Power
Conversion) on the AC and Ethernet lines.
When the Wi-Fi Router is connected to a local computer through Ethernet cables, the
computer must be properly grounded to the building/residence AC ground network. All
plug-in cards within the computer must be properly installed and grounded to the
computer frame per the manufacturer’s specifications.
Ensure proper ventilation. Position the Wi-Fi Router so that air flows freely around it and
the ventilation holes on the unit are not blocked.
Do not mount the Wi-Fi Router on surfaces that are sensitive to heat and/or which may be
damaged by the heat generated by the modem or its accessories.
Temperature Requirements
The Wi-Fi Router is capable of operating in an ambient temperature range of 0° - 40°C,
without any functional performance degradation.
FCC Part 15
This equipment has been tested and found to comply with the requirements for a Class B
digital device under Part 15 of the Federal Communications Commission (FCC) rules. These
requirements are intended to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will