User's Manual
Table Of Contents
- ARRIS Copyrights and Trademarks
- Patent Notice
- Safety Requirements
- Product Overview
- Installing the Wi-Fi Router
- Setting up an Internet Connection
- Setting Up a Wireless Network Connection
- Adding G.hn Extenders To Your Network
- Managing Your Wi-Fi Router and Connected Networks
- Start the Wi-Fi Router Web Manager
- Wi-Fi Router Web Manager Menu Options
- Get Help
- View the Wi-Fi Router Product Information
- Test Your Connection
- Set Up DHCP
- Set Up Dynamic DNS
- View Your IPv6 Configuration
- View Your USB Configuration and Status Information
- Disable LEDs on the Back Panel
- Back Up Your Wi-Fi Router Configuration
- Restore Your Configuration Settings
- Reset Your Configuration Settings
- Update Your Wi-Fi Router Firmware
- Exit the SBR-AC1200P Web Manager
- Protecting & Monitoring Your Wireless Network
- Prevent Unauthorized Access
- Change the Default User Name and Password
- Set Up Firewall Protection
- Set Up Remote Configuration Management
- Filter Devices Based on IP Address
- Filter Devices Based on IP
- Filter Devices Based on IP
- Restrict Wireless Access
- Prioritize Network Traffic Based on Media Type
- Configure Wireless Media Settings
- Set Up Parental Controls
- Set Up Port Triggers
- Set Up Port Forwarding
- Set Up the DMZ Host
Chapter 1: Safety Requirements
Release 33 ISSUE 1.3 December 2015 SURFboard SBRAC1200P Wi-Fi Router User Guide
Copyright ARRIS Enterprises, Inc. 2015. All Rights Reserved. 7
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING
Changes or modifications to this equipment not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
For the U.S. model, the country code is preset and cannot be changed. Per FCC regulations,
the country code setting for all Wi-Fi products marketed in the U.S. must be fixed to U.S.
operational channels only.
Operation of this device is restricted to indoor use only.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of
11.8 inches (30 cm) between the radiator and your body. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
Industry Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada. Son
fonctionnement est soumis aux deux conditions suivantes:
(1) Ce dispositif ne peut causer d'interférences; et(2) Ce dispositif doit accepter toute
interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement de
l'appareil.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.