User Manual
Table Of Contents
- Remove or Disable Conflicting Applications
- Check Your Computer’s Browser and System Requirements
- Choose a Computer and Connection Type
- Install the DSL Filter
- Ethernet Connection
- Wireless Connection
- USB Connection
- Windows 98/SE/2K/ME/XP
- Macintosh OS 10.1.4/10.1.5/10.2.0 - 10.2.8/10.3.3 - 10.3.8
- Ethernet Connection
- USB Connection
- Wireless Connection
- Ethernet Connection
- USB Connection
Add Computers to the Network
13
Wireless Connection
Requires a computer with an 802.11b/g wireless network adapter installed. Wireless adapters are
purchased separately from the 2Wire gateway.
Note: The 2Wire 2070, 2070V, and 270 gateways do not include wireless support. If you are
using a 2Wire 2070, 2070V, or 270 gateway, skip this section.
Figure 6. Gateway Connected to Second Computer Via Wireless
Note: If you use a 2Wire wireless adapter (PCI, PC card, or USB adapter) for wireless
networking, the gateway installation software automatically configures it to communicate with
the gateway during setup.
If you are NOT using a 2Wire wireless adapter, you must manually configure your adapter to
communicate with the gateway using the information on page 7.
1. Install your wireless adapter according to the manufacturer’s instructions (see note above).
2. Repeat “Run the 2Wire Setup Wizard” on page 10.