User's Manual

Appendix A: Install the Gateway on Other Operating Systems
17
USB Connection
Figure 8. Gateway Connected Via USB (Macintosh)
Note: Connecting your computer to the gateway using USB requires an available USB port. Only
one Windows or Macintosh computer can be directly connected to the 2Wire gateway using the
USB connection.
1. Install DSL phone filters according to the instructions on page 2.
2. With your computer powered on and the 2Wire Setup Wizard CD still in the CD-ROM drive, double-click
the 2Wire CD icon on your desktop.
3. Double-click 2Wire USB to begin the driver installation.
4. If you have set up an administrator name and password, the Authenticate screen opens. Enter your
administrator name and password and click
OK.
5. Follow the on-screen instructions. When the driver installation is complete, you will be prompted to
restart your computer.
6. After your computer restarts, connect the provided blue USB cable from the USB-PC port on the 2Wire
gateway to your computer’s USB port.
7. Open the network Control Panel by selecting the Apple icon > Control Panel > TCP/IP.
8. Verify that Connect Via: 2Wire USB Remote NDIS… is selected to set the network adapter as active.
9. Click Save to complete your installation.
10. Proceed to “Configuring the Internet Connection” on page 18.