User's Manual

19
Appendix B: Back-Up Key Codes
In most cases, you will receive a key code from your ISP. This key code is used to activate the 2Wire
gateway. If you did not receive a key code, you can use the key codes provided in the following table.
If your Internet Service Provider did not provide you with a
user name, password, or IP address to set up your Internet
connection, your broadband connection most likely uses
DHCP (Dynamic Host Configuration Protocol) and you should
use this key code.
52EU-2374-2262-22AT-B222
If your Internet Service Provider gave you a PPPoE username
and password to set up your Internet connection, your
broadband connection uses Point-to-Point Protocol over
Ethernet and you should use this key code.
52EU-2374-6262-22AS-B22Y
If your Internet Service Provider assigned you an IP address
to set up your Internet connection, your broadband
connection uses static IP (Internet Protocol) and you should
use this key code.
52EU-2374-2E66-22AS-B2TW
If your Internet Service Provider gave you a PPPoA username
and password to set up your Internet connection, your
broadband connection uses Point-to-Point Protocol over
ATM. In this case, you would use this key code and
Microsoft Dial-up Networking to connect to the Internet.
52EU-2374-A222-22AS-B2QK