Install Guide
Table Of Contents
- Remove or Disable Conflicting Applications
- Check Your Computer’s Browser and System Requirements
- Choose a Computer and Connection Type
- Install the DSL Filter
- Ethernet Connection
- Wireless Connection
- Non-2Wire Wireless Adapter Configuration
- a. The network name is the word “2WIRE” (in all capital letters), followed by the last three digits of the gateway serial number (for example, 2WIRE110).
- b. The encryption key is a 64-bit hex value, located beneath the bar code on the bottom of the 2Wire gateway. In the example, it is 4119627022.
- c. For Mac OS X users, you may need to enter the “$” character at the beginning of the encryption key (for example, $4119627022).
- Non-2Wire Wireless Adapter Configuration
- USB Connection
- Windows XP/2K/ME/98SE
- Macintosh OS 10.1.4/10.1.5/10.2.0 - 10.2.8/10.3.3 - 10.3.8
- Ethernet Connection
- USB Connection
- Wireless Connection
- Ethernet Connection
- USB Connection
Connect the First Computer to the Gateway
7
USB Connection
Figure 3. Gateway Connected Via USB
1.
Connect the provided AC power adapter from the 2Wire gateway’s POWER port to an electrical outlet.
The
POWER light on the front of the gateway should be green.
2. Connect the provided blue USB cable from the gateway’s USB port to the USB port on your computer.
3. Connect the provided gray telephone cable from the gateway’s PHONE LINE port to a telephone jack with
DSL service.
PHONE LINE
TELEPHONE
POWER
RESET
USB - PC
USB cable
AC power
DSL lter
Telephone wall jack
Computer
Gateway 2701
DRAFT ONLY
2Wire Confidential