Install Guide
Table Of Contents
- Remove or Disable Conflicting Applications
- Check Your Computer’s Browser and System Requirements
- Choose a Computer and Connection Type
- Install the DSL Filter
- Ethernet Connection
- Wireless Connection
- Non-2Wire Wireless Adapter Configuration
- a. The network name is the word “2WIRE” (in all capital letters), followed by the last three digits of the gateway serial number (for example, 2WIRE110).
- b. The encryption key is a 64-bit hex value, located beneath the bar code on the bottom of the 2Wire gateway. In the example, it is 4119627022.
- c. For Mac OS X users, you may need to enter the “$” character at the beginning of the encryption key (for example, $4119627022).
- Non-2Wire Wireless Adapter Configuration
- USB Connection
- Windows XP/2K/ME/98SE
- Macintosh OS 10.1.4/10.1.5/10.2.0 - 10.2.8/10.3.3 - 10.3.8
- Ethernet Connection
- USB Connection
- Wireless Connection
- Ethernet Connection
- USB Connection
Add Computers to the Network
12
USB Connection
Figure 5. Gateway Connected to Second Computer Via USB
1.
Connect the provided blue USB cable from the gateway’s USB-PC port to the USB port on your computer.
2. Install the USB driver (refer to page 8 for instructions).
3. Repeat “Run the 2Wire Setup Wizard” on page 9.
PHONE LINE
TELEPH
ONE
POWER
RESET
USB - PC
AC Power
DSL lter
Telephone wall jack
with DSL
Additional computer
with available USB port
First computer
with Ethernet card
DRAFT ONLY
2Wire Confidential