Install Guide
Table Of Contents
- Remove or Disable Conflicting Applications
- Check Your Computer’s Browser and System Requirements
- Choose a Computer and Connection Type
- Install the DSL Filter
- Ethernet Connection
- Wireless Connection
- Non-2Wire Wireless Adapter Configuration
- a. The network name is the word “2WIRE” (in all capital letters), followed by the last three digits of the gateway serial number (for example, 2WIRE110).
- b. The encryption key is a 64-bit hex value, located beneath the bar code on the bottom of the 2Wire gateway. In the example, it is 4119627022.
- c. For Mac OS X users, you may need to enter the “$” character at the beginning of the encryption key (for example, $4119627022).
- Non-2Wire Wireless Adapter Configuration
- USB Connection
- Windows XP/2K/ME/98SE
- Macintosh OS 10.1.4/10.1.5/10.2.0 - 10.2.8/10.3.3 - 10.3.8
- Ethernet Connection
- USB Connection
- Wireless Connection
- Ethernet Connection
- USB Connection
Add Computers to the Network
13
Wireless Connection
Requires a computer with an 802.11b/g wireless network adapter installed. Wireless adapters are
purchased separately from the 2Wire gateway.
Figure 6. Gateway Connected to Second Computer Via Wireless
1.
Install your wireless adapter according to the manufacturer’s instructions (see note above).
2. Repeat “Run the 2Wire Setup Wizard” on page 9.
Note: If you use a 2Wire wireless adapter (PCI, PC card, or USB adapter) for wireless
networking, the gateway installation software automatically configures it to communicate
with the gateway during setup.
If you are NOT using a 2Wire wireless adapter, you must manually configure your adapter to
communicate with the gateway using the information on page 6.
DSL
PHONE LINES
POWER
RESET
2
AC power
2Wire
DSL lter
Telephone wall jack
with DSL
Computer
(with 802.11g wireless
adapter installed)
Gateway 2701
DRAFT ONLY
2Wire Confidential