User's Manual
Table Of Contents
- Choose a Computer and Connection Type
- Ethernet Connection
- Wireless Connection
- USB to PC Connection
- Connecting to VDSL via CoAX
- Setting Up IPTV
- Gateway (System) Pages
- Broadband Link Pages
- Home Network Pages
- Firewall Pages
- Accessing the Management and Diagnostic Console
- System Summary Page
- Broadband Link - Summary Page
- Broadband Link - Statistics Page
- Broadband Link - Configuration Page
- Local Network - Status Page
- Local Network - Statistics Page
- Local Network - Device List Page
- Local Network - Wireless Settings Page
- Local Network - Configuration Page
- Enabling Router Behind Router Alert
- Local Network - Address Allocation Page
- Local Network - Configure the MoCA Network Page
- Local Network - MoCA Statistics Page
- Firewall - Settings Page
- Firewall - Detailed Information Page
- Firewall - Advanced Settings Page
- Troubleshooting - DSL Diagnostics Page
- Troubleshooting - Event Log Page
- Troubleshooting - Network Tests Page
- Troubleshooting - Upgrade History Page
- Troubleshooting Resets Page
- Advanced - Syslog Settings Page
- Advanced - Provisioning Info Page
- Advanced - Configure Time Services Page
- Advanced - Configure Services Page
- Advanced - DNS Resolve Page
- Advanced - Link Manager States Page
- Advanced - Detailed Log Page
- Step 1: Enable Public Network Mode
- Step 2: Allocate Public IP Addresses to the LAN Clients
- Step 3: Configure Firewall Rules
- Sample Configuration
- LED overview
Connect the Computer to the Gateway
9
USB to PC Connection
1. Connect the provided AC power adapter from the 3700HGV-B’s POWER port to an electrical outlet. After
the 3700HGV-B has completed its start up process, the
POWER light on the front of the 3700HGV-B
should be green.
2. Connect the provided blue USB cable from the 3700HGV-B’s USB-PC port to the USB port on the
computer.
3. If the VDSL signal is carried over the phone line, connect the provided gray phone cable from the
3700HGV-B's
PHONE LINE port to telephone wall jack. If the VDSL signal is carried over coax, refer to
page 11.
Install the 2Wire Gateway USB Driver - Windows
1. Insert the 2Wire setup CD in your computer’s CD-ROM drive.
2. Power on the computer. If the Add Hardware Wizard displays, follow the on-screen instructions. If
prompted to identify where to search for drivers, deselect
Floppy Disk drive and check CD-ROM drive.
3. After the driver installs click Finish to complete the driver installation. The Setup Wizard will resume
when the PC has rebooted.
Note: Microsoft Windows 98 users may be prompted to insert the Windows 98 installation CD-
ROM after installing the 2Wire gateway USB drivers. After the Windows 98 updates are complete,
remove the Windows 98 CD and reinsert the Setup Wizard CD into the CD-ROM prior to rebooting
the PC.