User's Manual
Table Of Contents
- Choose a Computer and Connection Type
- Ethernet Connection
- Wireless Connection
- USB to PC Connection
- Connecting to VDSL via CoAX
- Setting Up IPTV
- Gateway (System) Pages
- Broadband Link Pages
- Home Network Pages
- Firewall Pages
- Accessing the Management and Diagnostic Console
- System Summary Page
- Broadband Link - Summary Page
- Broadband Link - Statistics Page
- Broadband Link - Configuration Page
- Local Network - Status Page
- Local Network - Statistics Page
- Local Network - Device List Page
- Local Network - Wireless Settings Page
- Local Network - Configuration Page
- Enabling Router Behind Router Alert
- Local Network - Address Allocation Page
- Local Network - Configure the MoCA Network Page
- Local Network - MoCA Statistics Page
- Firewall - Settings Page
- Firewall - Detailed Information Page
- Firewall - Advanced Settings Page
- Troubleshooting - DSL Diagnostics Page
- Troubleshooting - Event Log Page
- Troubleshooting - Network Tests Page
- Troubleshooting - Upgrade History Page
- Troubleshooting Resets Page
- Advanced - Syslog Settings Page
- Advanced - Provisioning Info Page
- Advanced - Configure Time Services Page
- Advanced - Configure Services Page
- Advanced - DNS Resolve Page
- Advanced - Link Manager States Page
- Advanced - Detailed Log Page
- Step 1: Enable Public Network Mode
- Step 2: Allocate Public IP Addresses to the LAN Clients
- Step 3: Configure Firewall Rules
- Sample Configuration
- LED overview
65
Upgrade the Software
Gateway field upgrades are typically performed via CMS, which is the gateway remote management system.
The following procedure describes how to perform a local upgrade; however, because the gateway’s
configuration information is not retained when performing a local upgrade, upgrading via CMS is the
preferred method. Perform the local upgrade only if you cannot access the broadband link to upgrade via
CMS, or the target release is not published on CMS.
Note: This procedure assumes that you have been provided with a software image via CD, or
downloaded it from an ftp server.
Note: Do not disconnect the power cord from the gateway during an upgrade. Doing so will erase
all gateway information, and cause the gateway to fail.
1. Open a browser and enter http://home/upgrade. The following page opens.
2. Click CONTINUE. In the provided field, enter the location of the software image or click the Browse button
and navigate to the location where the image is stored. Click
UPGRADE NOW.
3. The gateway firmware is upgraded. The gateway will then reboot.