User's Manual

Declaration of Conformity 12
HomePortal® 5011NV/5012NV Intelligent Gateway Installation Guide Regulatory Information
Location – Environmental Considerations
Do not plug the AC/DC power adapter in an outdoor outlet or operate the gateway outdoors. It is not waterproof
or dustproof, and is for indoor use only. Any damage to the unit from exposure to rain or dust may void your
warranty.
Do not expose the residential gateway to high heat, dust, humidity, moisture, caustic chemicals, or oils. Keep the
gateway away from direct sunlight and any material that radiates heat, such as a stove or a motor.
Do not place the gateway in enclosed areas having restricted airflow, such as, electrical cabinet, closet, or
entertainment center. Allow adequate ventilation around the gateway for maximum air flow and cooling.
Declaration of Conformity
FCC / Industry Canada Compliance
This device has been tested and certified as compliant with the regulations and guidelines set forth in the
Federal Communication commission - FCC part 15, FCC part 68 and Industry Canada - ICES003 and RSS-210
Radio and telecommunication regulatory requirements / Le présent materiel est conforme aux specifications
techniques applicables d’Industrie Canada. Cet appareil numérique de la classe [*] est conforme à la norme
NMB-003 du Canada.
Manufacturer: 2Wire, Inc.
Model(s): 5011NV, 5012NV
Part 15 of FCC Rules
This device complies with Part 15 of the FCC Rules. The operation of this device is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
TIA 968 (Part 68 of FCC Rules) / IC CS-03
This equipment complies with the Telecommunication Industry Association TIA-968 (FCC part 68) and Industry
Canada CS-03 Telecommunication requirements. On the product is a label that contains, among other
information, the IC and FCC registration number and ringer equivalence number (REN) for this equipment. If
requested, this information may be provided to the telephone company.
m
Changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate this equipment.