User's Manual
Table Of Contents
- Contents
- Introduction
- Installing the i3822V (Outside Unit)
- Installing the iPSU (Power Supply Unit)
- Verifying the i3822V and iPSU Installations
- Installing the i38HG (Inside Unit)
- Troubleshooting
- Checking DSL links
- Checking the i3822V wiring
- Checking i3822V ports
- Checking i3822V LED status
- Verifying broadband operation and statistics
- Testing cables
- Performing an HPNA test
- Isolating HPNA issues
- Verifying voice services
- Verifying the iPSU connection
- Verifying the backup battery operation
- Bypassing i3822V electronics
- Regulatory Information
- Technical Specifications
- Index
16 Chapter 2 Installing the i3822V (Outside Unit)
4. Insert the drop wire from the network through the other opening on the grommet
entry.
5. Make sure that the red and green wires installed in the top round holes on each
station protector are firmly seated in the slots along the top of the holes. This
prevents them from dislodging when the nut on the top of the station protector is
loosened.
6. Use a 3/8” hex or flat blade screwdriver to loosen one of the station protectors by
turning it counter-clockwise to a full upright position.
ETHERNE T
TELCO ACCESS
Slot
DSL LINE 2DSL LINE 1
FROM C O
LINE 1
LINE 2
COAX
ETHERNET
TELCO ACCESS
TO TEST VOICE SERVICE PLUG IN WORKING PHONE
POWER
VDSL area