User's Manual
Table Of Contents
- Contents
- Introduction
- Installing the i3822V (Outside Unit)
- Installing the iPSU (Power Supply Unit)
- Verifying the i3822V and iPSU Installations
- Installing the i38HG (Inside Unit)
- Troubleshooting
- Checking DSL links
- Checking the i3822V wiring
- Checking i3822V ports
- Checking i3822V LED status
- Verifying broadband operation and statistics
- Testing cables
- Performing an HPNA test
- Isolating HPNA issues
- Verifying voice services
- Verifying the iPSU connection
- Verifying the backup battery operation
- Bypassing i3822V electronics
- Regulatory Information
- Technical Specifications
- Index
8 Chapter 1 Introduction
Service provider access
The service provider Telco access area is locked. Service provider personnel can
access this area by removing the Telco access cover. The i3822V has two cable
entries to provide wiring from the service provider and to inside the home. The left
entry provides the VDSL cable connection from the service provider to the i3822V.
The right entry provides a coaxial wiring connector that feeds the inside of the home
and a power connection for the power supply unit. It also provides connection access
to the customer premises phone wiring.
iPSU (power supply unit)
The Power Supply Unit (iPSU) supplies power to the i3822V and is installed by the
service provider. Unlike the i3822V, the iPSU must be installed in a sheltered area,
either inside the garage or home. If the iPSU is equipped with a backup battery, during
a temporary AC power outage, the power source is switched to the battery without any
interruption to subscribed services. When the AC power is restored, the power source
is switched back to the AC power supply. The switchover between the AC power
supply and the battery is automatic and without interruption of service.
DSL LINE 2DSL LINE 1
FROM C O
LINE 1
LINE 2
COAX
ETHERNE T
TELCO ACCES S
CO LINE 2
CO LINE 1
TO TEST VOICE SERVICE PLUG IN WORKING PHONE
POWER
Telco access cover
Left entry
Right entry