Full Product Manual

Installing the Wireless Router

Wireless Router SURFboard® SBR-AC1750 • User Guide

Figure 5 – SBR-AC1750 Connection Diagram

1. Check that a coaxial cable is already connected to a cable wall outlet or RF splitter (optional)

and your modem.

2. Disconnect the power cord from your modem to turn it off.

Note

: If your modem has a battery, remove the battery to confirm that the power is disconnected.

3. Disconnect the Ethernet cable connection from your modem.

4. Connect that Ethernet cable to one of the four white

Ethernet

ports on the rear of your

SBR-AC1750.

5. Connect the blue Ethernet cable (included) to the

Ethernet

port on the rear of your modem.

6. Connect the other end of the blue Ethernet cable to the blue

WAN

port on the rear of your

SBR-AC1750.

7. Reconnect the power cord to the

Power

port on your modem to turn it back on.

-or-

Reinsert the battery in your modem to turn it back on.

8. Wait approximately two minutes to allow your modem to fully power up.

9. Connect the power cord (included) to the

Power

port on your SBR-AC1750.

10. Plug the other end of the power cord into an electrical wall outlet.

Note

: This automatically powers ON your SBR-AC1750.

11. Check that the

Power

WAN

Wireless

, and connected

Ethernet

LEDs on the SBR-AC1750

front panel light up solid green.

If the

WAN

LED did not light up solid, check the Ethernet cable connection to make sure it is

properly connected.