User's Manual

IMPORTANT SAFETY INSTRUCTIONS
Before you install or use the apparatus, you must read and understand these Important Safety
Instructions. At all times, when using the apparatus, you must follow these Important Safety
Instructions to reduce the risk of fire, electrical shock and injury to persons.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
9. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10. Only use attachments/accessories specified by the manufacturer.
11. Use only with the cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
12. Unplug this apparatus during lightning storms or when unused for
long periods of time.
13. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
In addition to the Important Safety Instructions, please read the Safety Information
overleaf.
504T0498500
CONNECTING TO THE AC POWER SUPPLY
You must not plug your set-top box into the power supply until you have connected your set-top
box to the other equipment in your system.
This product is intended to be supplied with an approved listed Pace Direct Plug-In
AC/DC power adapter marked Class 2 or LPS and rated 12V, 1.5A for all IPW8000x series
models.
On the power supply unit there is a label that specifies the correct AC power supply input for it.
Do not connect the power supply unit to any supply voltage other than this.
Always connect the DC cord from the power supply unit to your set-top box before you insert the
power supply unit into the wall socket-outlet.
To disconnect power from your set-top box, always remove the power supply unit from the wall
socket-outlet (i.e., not by removing the DC cord from your set-top box). Therefore you must
install your set-top box near to the wall socket-outlet, which should be easily accessible.
If you are in any doubt about the power supply cord, its plug or its connection, or are not
certain that the electrical outlets you are using are properly wired and grounded, consult
a qualified electrician before proceeding any further.
INSTALLATION
The installation of your set-top box should be carried out by a qualified installer and should
conform to local codes.
Pace and are trademarks and/or registered trademarks of Pace plc.
Other trademarks listed herein are the property of their respective owners.
The model and serial number and electrical rating of your set-top box are on a label on its base.
Copyright © 2013 Pace plc. All rights reserved.