User's Guide
Table Of Contents
- Patent Notice
- Overview
- Safety Requirements
- Getting Started
- Installing and Connecting your Telephony Gateway
- Configuring Your Ethernet Connection
- Using the Telephony Gateway
- Troubleshooting
- The Telephony Gateway is plugged in, but the Power light is Off
- I'm not getting on the Internet (all connections)
- I'm not getting on the Internet (Ethernet)
- I'm not getting on the Internet (Wireless)
- My wireless Internet connection stops working sometimes
- I can get on the Internet, but everything is slow
- I don't have a dial tone when I pick up the phone - why?
- Glossary
Chapter 4: Installing and Connecting your Telephony Gateway
Release 34 ISSUE 1.0 July 2017 Touchstone TG3452 Telephony Gateway User Guide
© 2017 ARRIS Enterprises LLC. All Rights Reserved. 25
Note: You must set up your computer and other client devices to work with the security
settings on the TG3452. Refer to the documentation for your client device for instructions on
setting security. On most computer systems you only need to select the network name
(SSID) device and enter the encryption key.
1. Model number
2. Security label
If you need to modify the Telephony Gateway’s default wireless security settings, or if you
want to configure any other wireless LAN settings, refer to the following instructions.
Accessing the Configuration Interface
Follow these steps to access the configuration interface. You should have already set up the
TG3452 as described in Installing and Connecting your Telephony Gateway (page 18).
1. If security has been properly set up on your computer to access the wireless LAN on the
TG3452, use the connection utility for your operating system to connect to the wireless
LAN using its network name (SSID), as shown on the security label.