User's Manual

Safety

Getting

Started

Battery

Installation

Ethernet

Conﬁguration Usage Troubleshooting Glossary

Touchstone TG1672 Telephony Gateway User’s Guide

Mounting the Telephony Gateway

You can either mount the Telephony Gateway on a wall or place it on a desktop.

For wall-mount applications, you can mount the Telephony Gateway with the indi-

cators facing upward (vertical) or to the side (horizontal).

Tools and Materials

For wall-mounted installations, make sure you have the following tools and mate-

rials before proceeding:

• for mounting on drywall: Two 1/4” (6mm) drywall anchors (not included),

two #6 x 1.5” (38.1 mm) self-tapping panhead screws (not included), and

a drill with 1/4” (6mm) bit (not included)

• for mounting on plywood or studs: two #6 x 1.5” (38.1 mm) self-tapping

panhead wood screws (not included)

• screwdriver (ﬂat-blade or Phillips, depending on what kind of screws you

use)

• wall-mount bracket (order from your cable company)

Location

Always position the Telephony Gateway:

• within reach of an AC outlet. The power cord must reach the outlet without

stretching and without adding extension cords.

• near a cable outlet (to avoid long cable runs).

Instructions

Wall-mounting instructions

Note: When mounting the Telephony Gateway on drywall, try to position the

Telephony Gateway so at least one of the screws is fastened to a stud.

This may prevent the Telephony Gateway from pulling out of the wall in

the future. To prevent overheating of the Telephony Gateway, do not

block the ventilation holes on the sides of the unit.