User`s guide

Configuring RIP
Enabling RIP (Router Information Protocol) allows the WTM652 to act as a router
in your local network. RIP is primarily intended for use in an office environment.
Requirements
To successfully configure RIP, you must:
• have a static IP address assigned by your cable provider
• disable Network Address Translation (NAT) on the WTM652 (which means
you must either assign static IP addresses to all devices in your local net-
work or use a DHCP server to assign addresses)
Action
Follow these steps to configure RIP.
1 Click the Lan Setup link in the navigation menu, then click RIP Settings.
The RIPv2 Settings window appears:
Touchstone WTM652 Telephony Modem User’s Guide
Safety
Getting
Started
Battery
Installation
Installation
Wireless
Configuration
Ethernet
Configuration Usage Troubleshooting Glossary
50