User's Guide

Chapter 6: Appendix: ARRIS Software License, Warranty, Safety and Regulatory information
■
This device must be installed and used in strict accordance with manufacturer's
instructions, as described in the user documentation.
■
Comply with all warning and caution statements in the instructions. Observe all warning
and caution symbols that are affixed to this device.
■
To prevent fire or shock hazard, do not expose this device to rain or moisture. The device
must not be exposed to dripping or splashing. Do not place objects filled with liquids
such as vases; around, above, or in the proximity of the device. Do not use this product
near water. For example, near a bathtub, washbowl, kitchen sink, laundry tub, swimming
pool, or in a wet basement.
■
This device was qualified under test conditions that included the use of the supplied
cables between system components. To ensure regulatory and safety compliance, use
only the provided power and interface cables and install them properly.
■
Use only the power cord that was either supplied for this model in the original packaging
or supplied as a replacement by ARRIS or your service provider.
■
Installation of this device must be in accordance with national wiring codes and conform
to local regulations.
■
Operate this device only from the type of power source indicated on the device's
marking label either on the back or underside of the device. If you are not sure of the
type of power supplied to your home, consult your dealer or local power company.
■
Do not overload outlets or extension cords, as this can result in a risk of fire or electric
shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked
wire insulation, and broken plugs are dangerous. They may result in a shock or fire
hazard.
■
Route power supply cords so that they are not likely to be walked on or pinched by items
placed upon or against them. Pay particular attention to cords where they are attached
to plugs and convenience receptacles, and examine the point where they exit from the
device.
■
Place this device in a location that is close enough to an electrical outlet to
accommodate the length of the power cord.
■
Place the device to allow for easy access when disconnecting the power cord of the
device from the AC wall outlet.
■
Do not connect the plug into an extension cord, receptacle, or other outlet unless the
plug can be fully inserted with no part of the blades exposed.
■
Place this device on a stable surface.
■
Installation of an AC surge protector in the AC outlet to which this device is connected is
recommended. This is to avoid damaging the device by local lightning strikes and other
electrical surges.
■
Postpone installation until there is no risk of thunderstorm or lightning activity in the
area.
■
Do not cover the device or block the airflow to the device with any other objects.
Keep the device away from excessive heat and humidity and keep the device free from
vibration and dust.
■
Wipe the device with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do
not spray cleaners directly on the device or use forced air to remove dust.
SURFboard mAX User Guide Standard Revision W30/W31/W130/W133/W21/W121 65