User's Manual

Table Of Contents

Installation & User Manual

If a second subscriber (indoor) antenna is to be used, select a location

that is at least 16 meters (55ft) away from both the first subscriber

(indoor) antenna and the donor (outdoor) antenna. Once the antenna

is connected, adjust the sliding switch to enable the secondary

subscriber port (Ant 2).

Figure 1. CR300 Connections

Verify all cables are connected properly and connect the provided AC

to DC adapter to the unit. The power LED will illuminate, and the

status LED should briefly flash and then extinguish. The normal

operating condition is a green power LED with an extinguished status

LED.

If the status LED is amber and flashing, either an isolation problem

exists or too much signal is being received at the outdoor antenna. To

solve this problem, try relocating the antenna or rotate the antenna

(for directional antennas) until the amber LED extinguishes.

If the status LED is green and flashing, either an isolation problem

exists (try relocating the antenna) or a handset is operating too close

to the indoor antenna. If it was caused by a handset operating too

close, the status LED should extinguish when the handset is moved

further away from the antenna.