User's Manual

Table Of Contents

Installation & User Manual

Fault Reporting

The unit has an open collector output than can relay any fault

condition to an external device. This uses the third pin in the power

connector. This pin is rated at 12V, 200mA and is at ground potential

when a fault condition exists.

Figure 2 Power Connector Pinout

Operation

The in-building repeater operates automatically and does not

require user intervention. There are no user controls, except for a

sliding switch to allow a user to connect additional subscriber

antenna on the repeaters secondary port to increase coverage area.

The front panel has two LEDs. A green ‘Power’ LED indicates that

the repeater is operating. The ‘Status’ LED indicates several

conditions; consult the troubleshooting section for details.

Product

Maintenance

The CR300 does not require maintenance, as long as it is properly

installed following the guidelines stated in this manual. It is

recommended that all RF connectors be periodically checked for

corrosion, strain relief. Also periodically check the integrity of power

connections