Owner's manual

© 2013 ARRMA Durango Ltd.A subsidiary of Hobbico, Inc.
DESIGNED FAST. DESIGNED TOUGH.
16
Wheel Bearing Replacement
Rear Axle Maintenance (cont.)
45
Clean and check condition of
rear axle. If worn as shown
above, replace axle.
Refit driveshaft, camber-link, drive pin,
rear hex hub and rear wheel.
Rotate rear hub carrier to allow
better access and push axle up
through bearings.
3
Tools Required
7mm Nut Driver or Cross Wrench Long-nose Pliers
Every 50 runs or so it may be
necessary to inspect the wheel bearings for wear. Running the
model in dusty, sandy or wet conditions will mean that this will need
to be performed more frequently.
2
4
7
1
35
8
6
Remove front and rear wheels with 7mm nut driver/cross wrench. Remove
hex hub and drive pin from axles.
Turn steering and push axle
through front bearings.
Refit front axles, hex hubs, drive
pins and front wheels.
Refit rear axle, camber-link
balljoint, rear hex hubs, drive pins
and rear wheels.
Rotate rear hub carrier and
push axle through bearings.
Remove bearings from steering block.
Inspect, clean and replace if necessary.
Remove bearings from hub carrier. Inspect,
clean and replace if necessary.
Separate rear camber-link from ball joint with
long-nose pliers.
ARRMA-RC.COM/
SUPPORT/