User manual ARA4215V3BIT2-COPY-1

WWW.ARRMA-RC.COM

Low Voltage Cut Off

ESC Status LED

Battery Mode NiMH LiPo

4.5v 6.4v

Input Voltage 6-7 NiMh (7.2-8.4v) / 2S LiPo (7.4v) BEC Output 6.0v/2A Max

LED blinking slowly: Partial Forward/Reverse/Brake

LED solidly on: Full Forward/Reverse/Brake

Battery Plug

Setting 'Jumpers'

Power Switch Receiver Plug

(CH2)

Motor Connectors

Heat-sink

Throttle Setup

Do not move the throttle when switching the model on as the ESC will

automatically set the throttle neutral. A long beep will sound to confirm

setup.

Battery Mode: NiMH

Reverse: On

Factory Defaults

WARNING: When using LiPo batteries, always ensure the ESC is set to the correct battery

mode. Failing to do so may damage to the battery. Charging or using a damaged battery could

CAUTION: Heat sink may be hot after use.