User Manual

ManualsBrandsArrow Shed ManualsOtherArrow Shed AK600 Earth Anchor Kit

704990309

Model No. 697.60297

AK600

EARTH ANCHOR KIT

Owner's Manual & Assembly Instructions

PU01

This Anchor Kit contains (4) anchors and is recommended for

buildings no larger than 10 x 10 ft. (3,0m x 3,0m). Use two kits for

larger buildings.

IMPORTANT

FLOOR FRAME MUST BE LEVEL

AND SQUARE BEFORE ANCHORING

Follow the instructions supplied with your building to assemble the

Floor Frame. Place Floor Frame on level ground or on a prepared,

level building site. If optional Floor Brace Kits and more than one

Anchor Kit will be installed, attach Side Floor Frame Anchor

Gussets between Floor Braces.

NOTE: If your building has been assembled before anchoring,

refer to "Helpful Hints".

INTRODUCTION:

FOR STORAGE

BUILDINGS

TOOLS REQUIRED

· Carpenter's Level

· # 2 Phillips Screwdriver

This

Not

This

· Steel Bar or Iron Pipe

Earth

Anchor

Screw

Retainer

Gusset

Corner Anchor

Carpenter's

Level

Retainer

Floor Frame

of Building

ENTRANCE

Floor Frame

Limits

(Anchored)

Corner Anchor

Gusset

Side Floor Frame

Anchor Gussets

NOTE: Two (2) Anchor Kits shown.

Summary of content (4 pages)

PAGE 1
Owner's Manual & Assembly Instructions PU01 Model No. 697.60297 AK600 EARTH ANCHOR KIT FOR STORAGE BUILDINGS INTRODUCTION: This Anchor Kit contains (4) anchors and is recommended for buildings no larger than 10 x 10 ft. (3,0m x 3,0m). Use two kits for larger buildings. TOOLS REQUIRED · Carpenter's Level · # 2 Phillips Screwdriver IMPORTANT FLOOR FRAME MUST BE LEVEL This AND SQUARE BEFORE ANCHORING Not This · Follow the instructions supplied with your building to assemble the Floor Frame.
PAGE 2
PU02 Corner Gusset STEP 1 Installing Gussets 1. Attach a Gusset in each corner of Floor Frame. NOTE: On some Models, it will be necessary to drill 1/8" (3,2mm) holes in the Floor Frame at each Anchor Gusset. 2. All other Gussets (2 Kits) are to be attached to Side Floor Frames. Bend one flange on each of these Gussets before installing. On some Models (drill 1/8" 3,2mm holes) Side Gusset STEP 2 Installing Anchors 1.
PAGE 3
PU03 IMPORTANT: Anchor must go straight down into the ground. Do not allow Anchor to angle or wander from the starting point. Turn Clockwise into ground 4. Anchors are at proper depth when there is 1" (2,5cm) space under the eye as shown. 5. Move Floor Frame back in position over Anchors. Turn each Anchor slightly as necessary to align eye with slots in Gusset so that Floor Frame will rest on the ground.
PAGE 4
PU04 HELPFUL HINTS Retainer 1. Anchoring in very loose, sandy or rocky gound It may be necessary to install anchors deeper in the ground. Dig a hole approximately 12" (30,5cm) deep at each anchor location. Install anchors in bottom of hole in same manner as Step 2 except as follows: a. Insert a short length of 1/8" (0,3cm) steel cable thru eye of anchor and secure with a cable clamp as shown. b. Insert other end of cable thru Hole in Gusset. c.