User's Manual
Installing Sewing Machine into Your new Cabinet.
It may be helpful to read the directions for operating
the mechanism before proceeding with the following FIG. 16
steps. See page 16, and FIG. 19 on next page.
Step 1. Swing out the Leaf Support Wings and open leaves.
To prevent damage to Cabinet surface, place
cushioning material just to the left of cut-out. Lay the
machine on its back, on top of cushioning material.
Step 2. Take the cord from the foot control up from the bottom
through the slot on the right end of the cabinet Platform (see FIG. 16).
Step 3. Plug the cord into the right end of the sewing machine (see FIG. 17).
IMPORTANT: Do not place sewing machine to far out onto the
Leaf. The extra weight may cause the cabinet to flip over. This
could cause personal injury or damage to the cabinet and sewing machine.
Installing Sewing Machine Head
VERY CAREFULLY ATTACH THE SEWING MACHINE TO
THE CABINET IN THE FOLLOWING MANNER:
Step 4. Remove the extension table on the left side
of the sewing machine (Free Arm Position).
If it is detachable.
Step 5. Thread the (2 provided) Headmounting Bolts
into the two threaded holes located on the
bottom of your machine; twist tight to the
collar. Number and type of Bolts may vary
with different machines (see FIG. 18).
Step 6. Locate the appropriate platform holes
which position your machine in the top opening
to allow for use of the CUSTOM FIT plastic insert
(Sears Item #9801) when sewing in the flatbed
position. See Fig. 16 and Photo C on Page 17.
For assistance in locating the appropriate
platform holes please refer to FIG. 18B.
/
on page 16. _ ,_
Next, secure machine to Platform with
Washers and Wing Nuts by tightening
into place from underneath Platform
(see FIG. 18A).
Step 7. Lower machine onto the platform, aligning
bolts with the holes selected in the
platform. Some Machines may require
new holes to be drilled.
Step 8. Pushing the machine down, lower it
into the storage position; lift back
into the free-arm position, to check
operation.
Refer to operating instructions of the Air Lift
Mechanism on page 16. _.
Maintenance of Cabinet:
Clean as you do your other fine furniture.
using a soft cloth and polish.
Page 15
I I
I
/! ,
7
FIG. 18AJ
FIG. 18
Cabinet
E
/
\
/
/
)8300-15
18301-15
98302-15