User's Manual

47
Step 31Step 31
Step 31Step 31
Step 31
BX47
STEP
22
22
2
STEP
11
11
1
Spring Restraint CableSpring Restraint Cable
Spring Restraint CableSpring Restraint Cable
Spring Restraint Cable
STEP
33
33
3
11
11
1After door has been completely in-
stalled, raise door to a full open posi-
tion. Remove nut from bolt holding
the horizontal track to the spring sup-
port bracket, but do not remove bolt.
22
22
2Slip keyed end of
spring restraintspring restraint
spring restraintspring restraint
spring restraint
cable cable
cable cable
cable over shaft of bolt. Replace nut
and tighten securely.
33
33
3Thread spring restraint cable
through spring, making sure cable
goes through spring loops on each
end of spring. Fasten to hole shown
on angle of the horizontal track using
a #10-32x3/8" bolt and square nut
through keyed end of cable.
44
44
4Repeat above installation proce-
dure for the other spring.
NOTENOTE
NOTENOTE
NOTE
This spring restraint cable has been
manufactured in accordance with require-
ments of the California Department of
Housing and Community Development.