Instructions / Assembly
PARTS LIST
ANCHOR KIT #AK100
INTRODUCTION
This anchor kit is intended for use on all Arrow storage buildings.
TOOLS AND MATERIALS REQUIRED
● Carpenter's Level ● 1/4" Masonary Drill Bit(Supplied)
● Drill (Electric) ● #2 Phillips Head Screwdriver
● Safety Glasses ● Tape Measure
● 1/8" (3,2 mm) Drill Bit ● 3/8" Wrench
● 1/4" (6,4 mm) Drill Bit ● Hammer
● Work gloves & long sleeves
ASSEMBLY INSTRUCTIONS:
Read the instructions and study the illustrations carefully. Follow
the step by step instructions to properly Anchor your Storage
Building.
RETAIN THIS MANUAL AND PARTS LIST AFTER
ASSEMBLY FOR FUTURE REFERENCE.
CHECK THE CONTENTS:
Check the contents of carton against the Parts List. Identify parts
to those shown in the illustrations. This will help you become
familiar with the parts on sight.
SAFETY RULES:
● ●
● ●
● Make sure no one is in path while drilling.
● Wear safety glasses, work gloves and long sleeves
while drilling.
ANCHORING THE STORAGE BUILDING TO A
CONCRETE PATIO OR SLAB
This concrete Anchor Kit comes complete with masonary drill bit,
fasteners and easy to follow instructions. For proper installation,
it is important that the overall size of the patio/slab has approxi-
mately 9/16" (1,4 cm) clearance between frame and edge of
concrete around entire perimeter.
IMPORTANT: Make sure Floor Frame is level and square
before proceeding with the anchoring.
One Anchor Kit is recommended for most buildings. Anchors are
used at each corner and spaced evenly along the Floor Frame.
NOTE: The following must be considered before starting to drill
concrete for installation of Hold Down Clips:
1. If your building has Floor Frame Splices.
A. Assemble and position Floor Frame.
B. Mark and drill hole location as described above.
This kit contains four Gussets to anchor the Floor Frame corners.
If your building is supplied with Gussets (some models have them),
disregard the ones supplied with the building.
Key # Part # Description (Quan.)
1 8397 Corner Gusset (4)
2 8398 Hold Down Clip (11)
Anchor Bolt (16)
3 66159 #10 x 1/2" (13 mm) Screw (39)
Masonary Drill Bit-1/4" (1)
1 2 3 Hardware Kit
ENTRANCE
Limits of
Floor Frame
Slab To Extend 9/16" (1,4 cm)
Beyond Floor Frame
Anchor Bolt Location
Equally Spaced Along Floor Frame
Floor Frame Assembly
of Storage Building
It is important that the entire
floor frame be anchored after
the building is erected.
Anchor Bolt
Corner Gusset