User's Manual

Getting started 13
3.3.2 Charge battery
Warning
The handset must be charged for at least
24 hours before using it for the first time.
When the battery level becomes low, the
low battery sensor alerts you by sounding an
audible tone and blinking the battery icon.
If the battery level becomes exceedingly
low, the phone automatically switches off
and any function in progress will not be
saved.
Place the handset on the charging cradle
of the base station. A melody is emitted
if the handset is placed correctly.
The battery icon on the display
blinks during charge.
The battery icon becomes
steady when the handset is fully
charged.
Note
Optimal battery life is reached after 3
cycles of complete charging (over 15
hours) and discharging, allowing
approximately 12 hours of talk-time and
150 hours of stand-by time.
3.4 Welcome mode
Note
Depending on your country, the
WELCOME screen may not appear. In
this case, you are not required to select
your country/operator/language settings.
In the case when
WELCOME appears on
the screen before you first use your
handset, you need to configure it
according to the country of use.
After charging it for a few minutes, the
word
WELCOME appears in various
languages. Follow these steps to configure
your phone:
Scroll
: to the word WELCOME in
your preferred language and press
m SELECT to confirm your
selection.
Scroll
: to your country.
Press
m SELECT to confirm your
selection.
Press
: to your operator (if
necessary).
Press
m SELECT again to confirm
your selection.
• The default line settings and menu
language for the selected country
will be automatically configured.
• To set date/time, see “Set date and
time” on page 30.
Your phone is now ready for use.
Note
You can still make outgoing calls or
receive incoming calls without first
defining your country selection. The
welcome mode will display again after the
call.
Tip
You may change your country settings
anytime after the first configuration. (see
“Country selection” in chapter 8.8)
If there are no key presses for 15
seconds, the handset will automatically
return to idle mode. It will also return to
idle mode automatically when you place
the handset back on the base station.
!
1
2
3
1
2
3
4
5
CD650_IFU_EN_UK.book Page 13 Monday, June 23, 2008 3:42 PM