Instructions / Assembly

17
You will need for this page:
17AP
Using Small Screws, attach a Front Wall
Panel and Corner Panel to each corner
of the Front Wall as shown. The Corner
Panel should only be secured to the Front Wall
Panel where the Panels overlap. Do not secure the
Corner Panel to the Front Wall itself, this will be
done in Step 6. Also, leave the holes closest to the
Door open in the Front Wall Panel. These will be
used to attach the Door Jambs in Step 6.
6
Slide the Door Header Assembly down
onto the Front Wall Assemblies as shown
and secure with Small Bolts and Nuts. Once
these pieces are joined, take care when moving
them as the Door Header may bend.
5
(QTY: 8)
(QTY: 12)
Assemblies from previous page:
• Left Front Wall Assembly
• Right Front Wall Assembly
• Door Header Assembly
IMPORTANT: A minimum
of two people should be
used at all times when
handling or maneuvering
the Front Wall Assembly.
When installing the Front
Wall Assembly in the build-
ing, two people should hold
the Assembly in place until
it is secure. Failure to do so
could result in bending the
Front Frame and Fascia
pieces.
10618
Front Wall
Panel
2
10619
Corner Panel
2
Left Front Wall Assembly
Right Front Wall Assembly
SB
SB
SB
SB
SB
SB
SB
SB
SB SS
LEAVE HOLE OPEN
LEAVE HOLE OPEN
LEAVE HOLE OPEN
LEAVE HOLES OPEN
ALONG SIDE OF WALL
10618
10618
10618
10619
10619
10619
SS
SS
SS
SS
SS
Confi rm Front Frame of
Door Header Assembly is
facing outside of building.
Step 3: Continued