Instructions / Assembly

22
You will need for this page:
2
Position the Door Jambs as shown
and secure to the Front Wall Panel
using Small Screws. Double check
that the holes in the Door Jamb line up with
the holes in the Wall Post (Hinge). If they
do not, the Left and Right Door Jambs
are most likely switched.
Just as in the rear, carefully position
the Front Wall Assembly as shown
and secure with a Large Screw on
both sides. Install Front and Rear Side
Wall Channels using Large Screws.
1
22AP
(QTY: 4)(QTY: 2)
(QTY: 6)
Assemblies from Step 3:
• Front Wall Assembly
Side Wall
Channel
2
10886
LS
10886
10886
LS
LS
LS
LS
LS
LS
Right Door
Jamb
1
10622
Left Door
Jamb
1
80037
1062280037
LS LS
SS
10’x10’ (3,0 m x 3,1 m)
building shown.
SS
SS
SS
IMPORTANT: When installing
the Front Wall Assembly
in the building, two people
should position and hold the
Assembly in place until it is
secure. Failure to do so could
result in bending the Front
Frame and Fascia pieces.
If you purchased a Door Kit, install second Front Wall
Assembly on the rear of the building.
Step 6: Front Wall Install