Instructions / Assembly

36
Step 11: Continued
36H
You will need for this page:
At this point there should be only two Roof
Panels remaining. Install last two Roof Panels.
Because the last Ridge Cap is already in place
and has been secured at one end, you may need to
move the Ridge Cap slightly to secure the last two
Panels to the Main Roof Beams.
11
With all Roof Panels in place, secure the bottom
of Roof Panels to the Side Wall Angles with
Small Screws on both sides of the building.
13
DO NOT secure ends of Ridge Caps
until Peak Caps are in place.
Continue to apply weather stripping.
(QTY: 52+)
(QTY: 6)
• Bolts under Ridge Cap pass thru slots where
the End Roof Panel is overlapped by the Panel
next to it (labeled rib 5 below).
1
2
3
4
5
DO NOT fully tighten Ridge Cap
bolts until you have both Ridge
Cap bolts in place. This will ease assembly.
Bolts must be fully tightened before moving
on to the next page.
CUT
Finish weather stripping the roof under the
Ridge Cap and cut the tape just past the end
of the roof. Fold end of tape under roof edge.
12
10’x15’ (3,0 m x 4,6 m)
building shown.
Roof Panel
2
7743
SBSS
Alternate sides
while securing
roof panels.