Installation Guide

33
Seal Ridge
Step 11: Roof Assembly
33H
Roof Panel
6
7743
Attach Panels #5 - #10 according to the diagram on page 30.
Weather Stripping Tape should be applied in
a continuous strip along the length of the roof.
You will need for this page:
(QTY: 8)
(QTY: 48)
Begin weather stripping the roof ridge. Apply more of
the Weather Stripping after each additional Panel
is installed. A strip of Weather Stripping Tape 2”
(5,1 cm) long should be applied over each Bolt that is on a
rib overlap and under the Ridge Cap.
1
3
Secure rib #5 with two Small Bolts and Nuts as
shown to the right, and then cover with two 2” (5,1
cm) strips of Weather Stripping Tape.
2
Attach the fi rst four Panels (#5 - #8) in the order
given in the diagram on page 30. Use the Roof Panel
Diagram on page 30 while assembling the roof. You
will need to ‘roll’ the Panels to secure the ribs together, just
as on Wall Panels.
• Starting with rib #5 below, every rib that is over
a Truss should be secured with a Small Bolt and
Nut, and then sealed with a strip of Tape.
1
2
3
4
5
Install Panels #9 - #10 and seal with Weather
Stripping Tape.
4
Leave holes on ribs #1 and #2 open.
SBSS
SB
SB