Installation Guide

35
Step 11: Continued for Extension Modules
35H
(QTY: 32+)
Roof Panel
4+
7743
(QTY: 8+)
Continue to apply Weather Stripping.
Install two more Roof Panels. Continue to apply
Weather Stripping Tape as you go.
6
Where the last two Panels overlap over the
Truss, insert two Small Bolts and Nuts and seal
with two 2” (5,1 cm) strips of Tape.
7
Place strips of Tape over Bolts to seal.
You will need for this page:
Ridge Cap -
FR
1
10621
If you are erecting a 10’x10’ (3,0 m x 3,1 m) building, skip this page
and move on to page 36.
Overlap the last Ridge Cap installed with the next
Ridge Cap and secure with two Small Bolts and
Nuts as shown.
9
DO NOT fully tighten Ridge Cap Bolts
until you have both Ridge Cap Bolts
in place. This will ease assembly. Bolts must
be fully tightened before moving on to the next
page.
Repeat the steps on this page until you have only two Roof Panels
remaining. Before moving on to the next page, all Ridge Caps should be
in position, but the ends of the Front and Rear Ridge Caps at the front
and rear of the building should not be secured yet.
10
Ridge Cap -
Mid
0+
10680
SB
SBSS
Install two more Roof Panels.
8
SB
(Under Ridge Cap)