Instructions / Assembly

4
BEFORE YOU BEGIN...
04H
Your Commander Shed has a Modular Design.
This means your Commander
Shed can be extended to virtually any
length with the addition of Extension Modules.
Extension Modules can be installed when you fi rst
construct your building, or they can be added to it later.
How your building was shipped.
How you assemble your building will depend upon how many
Extension Modules you have purchased. See below to see
how many Modules are included in your building.
Nominal
Size
Extension
Modules
10’x10’ 0
10’x15’ 1
10’x20’ 2
10’x25’ 3
10’x30’ 4
Now that you have received your building you need to take inventory of
what you have to ensure nothing is missing.
Depending on the size building you purchased, your building arrived
in two or more cartons. Locate the carton label; you should have one
carton labeled C1GA and one labeled C2GA. Also, if you purchased
a building 15’ (4,6 m) in length or longer, you should have at least one
carton labeled GA5M.
C1GA -
C2GA -
GA5M -
Nominal
Size
Extension
Modules
3,0 m x 3,1 m 0
3,0 m x 4,6 m 1
3,0 m x 6,1 m 2
3,0 m x 7,5 m 3
3,0 m x 9,0 m 4
Please note: Most illustrations in this assembly manual depict a 10’x10’
(3,0 m x 3,1 m) building. A 10’x10’ (3,0 m x 3,1 m) building contains a
front and rear wall section and one truss section (see page 9). Each
additional Extension Module simply adds one more truss section to the
building (see page 11). Every truss section is identical to every other
truss section and the instructions clearly indicate how to assemble any
length building. Read all instructions carefully.
This carton contains the painted parts needed to erect
a 10’ (3,1 m) building. You should have one C1GA
carton.
This carton contains the un-painted parts needed to
erect a 10’ (3,1 m) building. You should have one C2GA
carton.
This carton contains the Extension Module. Review the
chart to the right to determine how many GA5M cartons
you should have received.