Instructions / Assembly

13
Next, insert the Upper/Lower Chord Truss Assembly
into the Truss Post Assembly as shown. Secure with
Large Screws. Do not tighten at this time. Repeat for
other side.
5
6
Attach Truss Splice to Truss using Large Bolts and
Nuts as shown below, but do not tighten at this time.
Temporarily secure the peak of the Truss using two
(2) Small Bolts and Nuts as shown.
13AP
Repeat for Additional Trusses
You will need for this page:
Assemblies from previous page:
• Truss Post Assembly (2)
• Chord Truss Assembly (2)
Nominal Size # of Modules # of Trusses
10’x10’ 3,0 m x 3,1 m 0 2
10’x15’ 3,0 m x 4,6 m 1 3
10’x20’ 3,0 m x 6,1 m 2 4
10’x25’ 3,0 m x 7,5m 3 5
10’x30’ 3,0 m x 9,0 m 4 6
The number of Trusses you will
need to construct your building
will depend on the size of your building. All
buildings require at least two Trusses. See the
chart to the right to determine the number of
Trusses needed for your building.
7
Attach Knee Braces
to Truss using Large
Screws as shown. Do
not tighten at this time. With
the Truss assembled, check
that the width of the Truss is
118 1/4” (300,4 cm) across the
top and bottom of the Truss.
If so, tighten all fasteners.
Repeat steps to build additional
Trusses.
Number of Trusses Needed
10881
10882
10883
10884
LS
LS
(QTY: 28)
LS
(QTY: 2)
SB
10885
Truss Splice
1
10646
Knee Brace
4
10885
118 1/4”
300,4 cm
LS
LS
LS
LS
LS
LS
LS
LS
SB
LB
LB
LB
LB
10885
10884
LB LB
10646
10646
(QTY: 8)
LB
Step 1: Continued