Instructions / Assembly

31
31H
An Awl may be used to help
align holes that are only slightly
misaligned. Take care not to bend
or warp the metal, and always practice
proper tool safety.
2
1
3
4
5
7
8
6
(QTY: 24)
(QTY: 8)
Right End
2
8578
Washer
Bolt
Nut
GABLE
You will need for this page:
LEAVE THESE HOLES OPEN
FASTEN TO NEXT PANEL
2
1
3
4
5
7
8
LEAVE THIS HOLE OPEN
6
LEAVE THIS HOLE OPEN
Secure the End Panel to the Main Roof Beam
by placing a Small Screw in hole #1 (from the
diagram below). Carefully remove the Gable
Edge Trim once the Panel is in position.
1
2
Fasten Panel to Gable by placing Small Bolts
and Nuts through holes #2 - #7. Fasten the
holes in order.
Work one corner at a time. Be sure
to fi nish a corner before moving on to
the next one.
3
Secure the Panel to the outer Roof Beam by
placing a Small Screw in hole #8. Repeat for
other three End Panels.
Left End
2
8579
If Roof Beam holes do not line up
with Roof Panel holes, shift the
building from left to right. If this does not
help, your building may not be level. Shim
the corners until holes line up.
8578
8579
8578
8579
SBSS
10’x10’ (3,0 m x 3,1 m)
building shown.
Step 10: End Panels