Installation Guide

Level
12
12M
You will need for this page:
Step 1: Continued
After Floor is square, tighten bolts
holding Floor Sections together.
10744
Floor Section
1
10743
F/R Floor
Section
1
10741
1
F/R Floor
Channel
IMPORTANT: IF STORAGE UNIT
IS NOT SQUARE, DOOR WILL NOT
CLOSE PROPERLY!
(QTY: 2)
SB
(QTY:5)
SS
SS
SS
SS
SB
SB
10741
10743
10744
5
7
SS
SS
6
6
Slide Floor Section and Front/
Rear Floor Section into place.
Secure using two (2) Sand Bolts
and Nuts at the middle.
5
Secure ends of Floor Section to
the Side Channels using two (2)
Sand Screw as shown above.
6
Attach Front/Rear Floor Channel
using three (3) Sand Screws as
shown.
7
Once Floor is complete, turn completed fl oor over. At this time, take a moment to ensure the unit
is level and square. Measure diagonally, when the diagonal measurements are equal, the Floor
is square.
8