Installation Guide

36
80083
10840
You will need for this page:
Step 17: Roof Assembly
36AI
Working one (1) Panel at a time, secure Right Roof Panel to Header
Assembly by placing one (1) Sand Screw in hole #1 (from the diagram
below). Carefully remove the Gable Edge Trim once the Panel is in
position. Do not discard the Edge Trim it will be used again on step 20.
1
Right Roof
Panel
1
10840
Left Roof
Panel
1
80083
Fasten Panel to Gable by placing Sand Bolts through holes #2, #3,
#4, #5, and #6. Fasten the holes in order.
2
Secure Panel to Roof Beam and Rear Wall Angle by placing one (1)
Sand Screw in holes #7 and #8. Repeat for other End Panel.
3
(QTY: 10)
(QTY: 6)
FRONT
SS
SB
LEAVE THESE HOLES OPEN
4
5
6
3
2
1
7
LEAVE THESE HOLES OPEN
FASTEN TO NEXT PANEL
8
Washer
Bolt
Nut
GABLE
An Awl may be used to
help align holes that are only
slightly misaligned. Take care
not to bend or warp the metal, and
always practice proper tool safety.
Work one (1) Panel at a time. Be sure
to fi nish a Panel before moving on to
the next.