Installation Guide

32
You will need for this page:
Step 13: Roof Assembly
32AB
Working one (1) Panel at a time, secure Right Roof Panel to Header
Assembly by placing one (1) Sand Screw in hole #1 (from the diagram
below). Carefully remove the Gable Edge Trim once the Panel is in
position.
1
Right Roof
Panel
1
10840
Left Roof
Panel
1
80083
Fasten Panel to Gable by placing Sand Bolts through holes #2, #3,
#4, #5, and #6. Fasten the holes in order.
2
An Awl may be used to
help align holes that are only
slightly misaligned. Take care
not to bend or warp the metal, and
always practice proper tool safety.
Work one (1) Panel at a time. Be sure
to fi nish a Panel before moving on to
the next.
Secure Panel to Roof Beam and Rear Wall Angle by placing one (1)
Sand Screw in holes #7 and #8. Repeat for other End Panel.
3
(QTY: 10)
(QTY: 6)
80083
10840
FRONT
SS
SB
LEAVE THESE HOLES OPEN
4
5
6
3
2
1
7
LEAVE THESE HOLES OPEN
FASTEN TO NEXT PANEL
8
Washer
Bolt
Nut
GABLE