Use and Care Manual
6
Step 5: Floor Assembly
18
18AB
(QTY: 8)
SS
Front
10849
2
10850
2
10850
10850
10849
10849
Assemble the four (4) corners of the
Floor Frame using two (2) Sand
Screws at each corner as shown.
1
Overlap Floor Frames as shown. Set Floor Frame
with large holes on top at each corner.
The Floor Frame must be BOTH square AND
level or the holes will not line up properly.
The remainder of the building assembly requires many hours and more than
one person. Do not continue beyond this point if you do not have enough
time to complete the assembly today. A partially assembled building can be severely
damaged by light winds.
Do NOT fasten your Floor Frames to your Base at this time. You
will anchor your building after it is erected.
When diagonal measurements
are equal, the Frame is square.
Front/Rear
Floor Frame
Side Floor
Frame
Level
You will need for this page: