Use and Care Manual

Roof Install Prep Page

31AB

Measure the building diagonally again to make

sure the building is square. The building should

be square at the base and at the top. This will

make roof panels ﬁ t better and holes will better

align.

Whenever a crimped rib and an uncrimped rib meet,

place the crimped rib UNDER the uncrimped rib.

Crimped Rib

Uncrimped Rib

Be sure to carefully follow the Roof Panel

Placement Order Diagram on this page.

If Roof Beam holes do not line up with Roof

Panel holes, shift the building from left to right. If

this does not help, your building may not be level.

Shim the corners until holes line up.

Use the information on this page to complete step 13.

The building is square when diagonal measurements are equal.

FRONT

Roof Panel Placement Order

5 23 4

10837 1083710838 8008310840