Use and Care Manual

14
6615
Rear Wall
Angle
2
You will need for this page:
Step 2: Wall Frames
Overlap two (2) Rear Wall Channels so that three
(3) holes align as shown. Insert one (1) Sand Bolt
and Nut through the center hole. Set aside for use
in Step 13.
2
1
Overlap two (2) Rear Wall Angles so that three
(3) holes align as shown. Insert one (1) Sand Bolt
and Nut through the center hole. Set aside for use
in Step 10.
14AH
(QTY: 2)
SB
Check that the fi nished length of the assemblies is
94 5/8” ( 240,3 cm).
3
Overlap parts so three
(3) holes align.
9924
Place bolt and nut through
center hole only.
9924
9924
6615
6615
Overlap parts so three
(3) holes align.
6615
Place bolt and nut through
center hole only.
Finished Length
94 5/8” ( 240,3 cm)
6 1/8” (15,6 cm)
Overlap Length
9924
Rear Wall
Channel
2