Use and Care Manual

6
Step 8: Floor Assembly
21
21AH
(QTY: 8)
SS
Front
10850
10850
Assemble the four (4) corners of the
Floor Frame using two (2) Sand
Screws at each corner as shown.
1
Overlap Floor Frames as shown. Set Floor Frame
with large holes on top at each corner.
The Floor Frame must be BOTH square AND
level or the holes will not line up properly.
The remainder of the building assembly requires many hours and more than
one person. Do not continue beyond this point if you do not have enough
time to complete the assembly today. A partially assembled building can be severely
damaged by light winds.
Do NOT fasten your Floor Frames to your Base at this time. You
will anchor your building after it is erected.
When diagonal measurements
are equal, the Frame is square.
10850
2
Side Floor
Frame
Level
Assemblies from Step 1:
• Front/Rear Floor Frame Assemblies (2)
Front/Rear Floor
Frame Assembly
Front/Rear Floor
Frame Assembly
You will need for this page: