Owner's Manual

13
CORRECT
INCORRECT
Long Leg
on top.
Door Slide
END VIEW
9396
Door Track
1
You will need for this page:
Step 1: Door Track/Header Assembly
Using the door track, with small holes on top,
join the header, short legs on top, as shown
using screws.
1
2
Position door slides onto the legs, from the
end of door track, as shown. Set this piece
aside for use in Step 4.
13BL
10572
Front Header
1
(QTY:8)
SS
66769
66769
The door track/header assembly supports
the sliding doors and reinforces the front
wall. It is made up of 2 pieces.
Door Slide
4
To remove or install Door Slides:
• Remove Doors from Slides and set aside.
• Using pliers, bend down a corner of the Door Track.
• Remove or install Door Slides.
• Carefully bend the corner back into position.
Slides should be installed in Door Track prior to installation. However, if this step is overlooked
or if the Slides need to be removed for maintenance, the following procedure may be used.
Slide all four (4) Door Slides into Track
9396
10572