Use and Care Manual

The gables go on top of the front and
rear walls to support the roof beams.
NOTE
The gables are packed nested
together and might be mistaken
as one piece. Carefully separate
them before continuing.
1 Apply green edge trim to the top
edge of the large left gables, small
left gables, large right gables and
small right gables, cut to length.
2 Apply clear edge trim to the edge
of the large left gables and the large
right gables, cut to length.
3 Join the large gables to the small
gables on the left and right sides us-
ing four bolts, washers and nuts on
each side. This part of the gable is
called the outer gable leg.
4 Attach the four roof beam
brackets to the outer gable legs
using two bolts in the two bottom
holes of the four holes that align.
 Parts Needed For 
Gable Assemblies
Step 11
SO24et ctr
 6108 Large Right Gable (2)
 6109 Large Left Gable (2)
 6114 Small Right Gable (2)
 6115 Small Left Gable (2)
 6085 Roof Beam Bracket (4)
STEP
1
STEP
3
6085
Roof Beam Brackets
69835
Green Edge Trim
(Plastic Piece)
Washer
6109
6115
6115
6109
FRONT
69835
Green Edge Trim
(Plastic Piece)
67521
Clear Edge Trim
(Plastic Piece)
6108
STEP
4
6114
2
STEP
To avoid mishap on the sharp
edge the edge trim must remain
in place on the top edge of the
gable until right and left roof
panels are in place.
CAUTION:
(8)
(16)
24