Use and Care Manual

Step 14
SO27et ctr
 Parts Needed For 
Right Roof Panel
 6188 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Install the fi rst roof
panel at the back right corner of the
building. Each screw and bolt in the
roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fi t better, and holes will
align. Don't anchor the fl oor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to at-
taching the roof panels.
1 Locate the roof panels and fi nd the
right roof panel part number 6188.
2 Position a right roof panel at the
back right corner and fasten to the
top roof beam using screws.
3 Remove edge trim from the left
gable under the roof panel.
4 Continue fastening the right roof
panel to the gable and lower roof
beam using screws, bolts and nuts as
shown. Do not fasten the lower end
of the panels to the side wall angles
at this time.
(6) Screws
6188
STEP
1
FRONT
Right Roof Panel
6188
1 thru 3
4
5
6
7
8
9
10
11
thru
13
STEP
2
Hint: Follow the fastener sequence
shown for proper alignment.
STEP
3
STEP
4
Bolt
(7)
Nut
Washer
Gable
(6) (7)
27