Instructions / Assembly

Step 13
B26et
 Parts Needed For 
Right Roof Panel
 8466 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fi t better, and holes will
align. Don't anchor the fl oor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels by their
numbers. Note the sequence and
position they are to be installed.
2 Position a right roof panel at the
back right corner and fasten to the
top roof beam using a screw.
8466 Right Roof Panel
FRONT
Washer
Bolt
Gable
STEP
2
STEP
1
Nut
2
3
4
5
6
1
7
8467
7875
7875
8466
8467
7875
7875
8466
8
6
2
4
1
5
7
3
FRONT
3 Remove edge trim from the left gable under
the roof panel.
4 Continue fastening the right roof panel to
the gable and lower roof beam using screws,
bolts and nuts as shown. Do not fasten the
lower end of the panels to the side wall angles
at this time.
Hint: Follow the fastener sequence
shown for proper alignment.
STEP
3
STEP
4
(2) (5)
26