Instructions / Assembly

Step 6
BL17
● Parts Needed For ●
Corner/Front Splice
Trim
●●
●●
● 9670 Corner Trim (four)
●●
●●
● 9669 Front Splice Trim (three)
17
1 Fasten front splice trim to the
seam where front facia meets with
four #10 screws.
2 If a special mounting board was
used, use remaining front splice trim
pieces to cover ends of board, in-
stead of corner trim. Fasten using
two #10 screws.
3 Position corner trim to inside
corners with short flange to facia and
fasten with two #10Ax3/8" (10 mm)
screws. Position corner trim to out-
side corners with long flange on the
front facia, and fasten with four #10
screws.
Repeat procedure on opposite end
of unit.
Mounting Board
9669
9670
Short Flange
9670
Long Flange
9670
9670
STEP
3
STEP
2
9669
STEP
1