Owners manual

Step 2
SS15
15
● Parts Needed For ●
Frame Assemblies
The main frame pieces reinforce the
walls. These piece will later be in-
stalled at the top edge of the side
walls and the rear wall. Proceed as
follows:
1 Overlap the rear wall angle pieces
as shown in the figure and fasten
them together with one bolt in the
center hole.
2 Make two side wall angles by
overlapping the side wall angle
pieces as shown. Fasten each set
together with one bolt thru the sec-
ond large hole from the end of each
part.
3 Set the assemblies aside. You will
use them later.
●●
●●
● 5986 Rear Wall Angle (2)
●●
●●
● 10391 Side Wall Angle (4)
STEP
1
STEP
2
Rear Wall Angle
118 1/8" 3,0m
5986
5986
10391
Side Wall Angles
157 3/8" 4,0m
Rear Wall Angle 118 1/8" 3,0m
Side Wall Angles 157 3/8" 4,0m (2 Assemblies)
10391