Owners manual

1 Install three ridge caps on the
completed roof section using bolts
and nuts. Fasten roof panel overlaps
not used for ridge cap. Cover the
head of bolt with the 3" (8cm) piece of
weather stripping tape. Do not fasten
the ends of the ridge caps until in-
structed to do so.
2 Install the second ridge caps over-
lapping the first ridge caps while in-
stalling the remaining narrow roof
panels. Cover the notched areas of
the roof panels with strips of weather
stripping tape and continue weather
stripping the ridge.
3 Fasten the lower end of the panels
to the side wall angles using screws
and washers. Use bolts and nuts
through wall angle overlaps at the
bottom of panel.
Reducing Large Gable Bulge
Loosen eight bolts and nuts shown.
Apply pressure with one hand at the
peak of the gable and tighten bolt #1.
Keeping pressure on the gable work
down the slope tightening each bolt.
Excess material will overlap smaller gable
at seam. Once material bulge is worked
out tighten four vertical bolts that con-
nect the large and small gables.
●●
●●
● 8840 Ridge Cap (3)
●●
●●
● 7954 Roof Panel (2)
●●
●●
● 8486 Ridge Cap (3)
Step 16
PS29
● Parts Needed For ●
Ridge Caps & Panels
STEP
1
8840
7954
8840
STEP
7954
8840
STEP
2
FRONT
29
8486
Cut
Weather Stripping
and Fold Under
8486
FRONT
8486
3